+91 422 2535636
Your Cart

 

Home Products10" Water Filled Motors (Eco Series)

10" Water Filled Motors (Eco Series)

Tormac ECO series motors are squirrel cage, water filled and water cooled rewindable type. The winding of these two pole motors are made of a special water proof wire of pure electrolytic copper insulated with synthetic film or thermoplastic material. All single phase motors are fitted with thermal protector to avoid winding burnouts. The stator shell, housing shell and motor base are made of fabricated S.S. 304 / 316 which prevents the motor from corrosion.

These motors are prefilled environmentally deionised water which acts as a lubricant and coolant. The prefilled water level to be ensured at the time of installation. In case of noticing any loss of volume it must be topped up with pure, cold, clean, fresh water to avoid incipient failures due to over heating. A uniquely designed thrust bearing with high thrust capacity and good quality shaft seals are used to enhance the strength and durability. All single phase motors are supplied with suitable control boxes. The main advantage of rewindable motor construction is making the repair and rewinding easier and hassle free at field levels. All Tormac motors are produced in accordance with ISO 9001 standards and with NEMA standard mounting dimensions.

  • Highly reliable, tried & tested.
  • Highly efficient
  • Stainless steel stator shell, motor base and housing shell to prevent corrosion.
  • The high quality soft seal and sand guard prevent ingress of liquid and sand.
  • Uniquely designed thrust bearing with stand high down thrust loads.
  • Higher starting torque and service factor to run in tough conditions.
  • The shaft is designed for optimal power transmission.
  • End connections and shaft extension are designed according to NEMA standards.

esce.png SiteLock